LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Power Steering Pump Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump from the vehicle. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .
    2. Fig 1: View Of Power Steering Pump Drive Shaft Seal
    GM1555824Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use the shim stock in order to protect the drive shaft.
  2. Use a chisel in order to cut and remove the seal.
scientia non olet · About LEMON Manuals