LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Power Steering Gear Replacement (Non Rack and Pinion) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pitman Arm, Power Steering Gear, Washer & Nut
    GM398127Courtesy of GENERAL MOTORS CORP.
  1. Install the pitman arm to the power steering gear.
    2. NOTE: Refer to Fastener Notice .
  2. Install the pitman arm to power steering gear retaining nut and washer.

    Tighten:  Tighten the nut to 250 N.m (184 lb ft).

    3. Fig 2: View Of Power Steering Gear & Bolts
    GM340417Courtesy of GENERAL MOTORS CORP.
  3. Install the steering gear to the frame and install the retaining bolts.

    Tighten:  Tighten the bolts to 150 N.m (110 lb ft).

    4. Fig 3: Pitman Arm To Relay Rod Nut (Non Rack and Pinion)
    GM828839Courtesy of GENERAL MOTORS CORP.
  4. Install the pitman arm to the relay rod.
  5. Install the pitman arm to the relay rod nut.

    Tighten:  Tighten the nut to 62 N.m (46 lb ft).

  6. Install the intermediate shaft to the steering gear. Refer to Lower Intermediate Steering Shaft Replacement .
  7. Remove the caps or plugs from the steering gear and hoses.
  8. Install the hoses to the steering gear.

    Tighten:  Tighten the hoses fittings to 32 N.m (24 lb ft).

  9. Install the engine protection shield, if equipped. Refer to Engine Shield Replacement .
  10. Remove the safety stands.
  11. Lower the vehicle.
  12. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals