LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (With Gas Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Steering Gear Inlet Pipe/Hose (With Hydroboost)
    GM650863Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Installing Hoses Without Twists or Bends Notice .
  1. Route the hose in the same position the hose occupied prior to removal.
  2. Install the power steering gear inlet hose (1) to the brake booster (2). Hand tighten only.
    3. NOTE: Refer to Fastener Notice .
  3. Install the power steering gear inlet hose to the power steering gear.

    Tighten:  Tighten both power steering gear inlet hose fittings to 32 N.m (24 lb ft).

  4. Remove the drain pan from under the vehicle.
  5. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals