LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Brake Booster Inlet Hose
    GM650858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Power Steering Hose Disconnected Notice .
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Shield Replacement .
  3. Install a drain pan under the vehicle.
  4. Remove the brake booster inlet hose from the power steering pump (3).
  5. Lower the vehicle.
  6. Remove the brake booster inlet hose (1) from the brake booster (2).
  7. Remove the brake booster inlet hose from the vehicle.
scientia non olet · About LEMON Manuals