Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Support the lower control arms at curb height.
- Perform the following procedure before installing the bolts:
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489).
- Install the link assemblies.
- Install the link bolts.
- Install the nuts to the link bolt assembly.
Tighten: Tighten the nuts to 23 N.m (17 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.