LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Shield Replacement .
    3. Fig 1: Insulators & Stabilizer Shaft
    GM793300Courtesy of GENERAL MOTORS CORP.
  3. Remove the insulator clamp bolts.
  4. Remove the clamps.
  5. Remove the insulators.
  6. Inspect all of the parts for wear and damage.
scientia non olet · About LEMON Manuals