LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Insulator On Stabilizer Shaft
    GM793301Courtesy of GENERAL MOTORS CORP.
  1. Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.
    2. Fig 2: Insulators & Stabilizer Shaft
    GM793300Courtesy of GENERAL MOTORS CORP.
  2. Install the insulators to the stabilizer shaft.
  3. Install the stabilizer shaft.
  4. Install the clamps over the insulators and the stabilizer shaft.
    5. NOTE: Refer to Fastener Notice .
  5. Install insulator clamp bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the engine protection shield. Refer to Engine Shield Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals