Stabilizer Shaft Insulator Replacement (1500 Series)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stabilizer Shaft Insulator & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Stabilizer Shaft Bolts (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft) Tip: Remove the bolts from the stabilizer shaft bracket. Loosen the other stabilizer/shaft bracket bolts. DO NOT remove.
2	Stabilizer Shaft Bracket Tip: Remove the bracket from the stabilizer shaft insulator.
3	Stabilizer Shaft Insulator Tip: Remove the stabilizer shaft insulator from the stabilizer shaft. The stabilizer shaft insulator slits must be facing the rear of the vehicle.