LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Front Suspension System) >> Repair Instructions >> Spring Jounce Bumper Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Jounce Bumper Stud & Nut
    GM348561Courtesy of GENERAL MOTORS CORP.
  1. Install the jounce bumper.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nut to the jounce bumper stud.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  3. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals