Shock Absorber Replacement (2500 Series)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Shock Absorber Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Shock Absorber Retaining Nut NOTE: Refer to Fastener Notice . Tighten: 24 N.m (17 lb ft) Tip: Support the lower control arm with a safety stand.
2	Insulators (Qty: 2) Tip: Install the lower insulator, which is smaller than the upper insulator and plastic pilot ring. Install the upper insulator, which is the larger of the 2 insulators.
3	Retaining Nut Tighten: 80 N.m (59 lb ft)
4	Mounting Bolt
5	Shock Absorber Tip: If replacing the shock absorber, refer Shock Absorber Disposal for the proper disposal procedure.