LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement (9.5 HD Axle) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
  4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5 LD Axle)  or Rear Axle Shaft Replacement (9.5 HD Axle) .
    5. Fig 1: Removing The Axle Shaft Seal And The Bearing From The Axle Housing Usingj 29712
    GM685944Courtesy of GENERAL MOTORS CORP.
  5. Remove the axle shaft seal and the bearing from the axle housing using the J 29712  . See Special Tools .
scientia non olet · About LEMON Manuals