LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement (9.5 HD Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing The Axle Shaft Bearing Using J 23690 Or J 29709 & J 8092
    GM695758Courtesy of GENERAL MOTORS CORP.
  1. Install the axle shaft bearing using the J 29709  (1) and the J 8092  (2). See Special Tools .
  2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    3. Fig 2: Driving J 21128 Or J 29713 Into The Bore Until The Axle Shaft Seal Bottoms Flush With The Tube
    GM695762Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft seal using the J 29713  . See Special Tools .
  4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  5. Install the axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5 LD Axle)  or Rear Axle Shaft Replacement (9.5 HD Axle) .
  6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Fill the rear axle. Refer to Lubricant Replacement - Rear Drive Axle (8.6 Inch Axle)  or Lubricant Replacement - Rear Drive Axle (9.5 Inch LD Axle)  or Lubricant Replacement - Rear Drive Axle (9.5 Inch HD Axle) .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals