Left Side Gear Backlash Adjustment

Fig 1: View Of Left Side Gear Thrust Washer
Courtesy of GENERAL MOTORS CORP.
1. Install the new left side thrust washer into the flange-end of the differential case.
Fig 2: View Of Left Side Gear Cam Unit & Clutch Disc Assembly
Courtesy of GENERAL MOTORS CORP.
2. Install the left side locking differential side gear cam unit and clutch disc assembly into the differential case.
3. Install the differential pinion gears with the deferential pinion gear thrust washers into the differential case.

   Align the openings of the differential pinion gears and the differential pinion gear thrust washers to the pinion shaft opening in the differential case.

4. Install the pinion shaft. It may be necessary to press down on the side gear in order to align the pinion gear shaft opening with the pinion shaft opening in the differential case.

   If the pinion shaft cannot be installed after pressing on the side gear, replace the locking differential clutch disc thrust washer with a thinner washer.

NOTE: Refer to Fastener Notice in Cautions and Notices.
5. Install the pinion shaft lock bolt.

   Tighten:  Tighten the pinion shaft lock bolt finger tight.

6. Rotate the pinion gear closest to the lock bolt so that one of the teeth is pointing downward, perpendicular to the ring gear flange.
7. Install a brass drift between the side gear and the pinion shaft.

   Press the brass drift in far enough in order to compress the clutch discs.

Fig 3: Measuring Backlash Of Differential Pinion Gear & Side Gear
Courtesy of GENERAL MOTORS CORP.
8. Measure the backlash of the pinion gear and the side gear by doing the following:
   1. Install the J 7872  (1) to the ring gear flange. See Special Tools .
   2. Loosely clamp the J 8001-3  (2) onto the stem on the J 7872  (1). See Special Tools .
   3. Place the contact pad of the J 8001-3  on one of the teeth of the pinion gear closest to the pinion shaft lock bolt. See Special Tools .

      Turn the dial of the J 8001-3  until the needle and the dial face indicate ZERO. See Special Tools .

   4. Tighten the lock nut of the J 8001-3  finger tight. See Special Tools .
   5. Pull the pinion gear firmly into the differential case seat.
   6. Rotate the pinion gear back and forth.
   7. Measure the backlash.

      Specification:  The backlash between the differential pinion gears and the locking differential side gear cam unit should be 0.279-0.432 mm (0.011-0.017 in).

9. If the backlash is too large, install a thicker locking differential clutch disc thrust washer and recheck the backlash.
10. If the backlash is too small, install a thinner locking deferential clutch disc thrust washer and recheck the backlash.

Locking differential clutch disc thrust washers are available in the following sizes:

Washer Sizes: 

• 0.559 mm (0.022 in)
• 0.686 mm (0.027 in)
• 0.813 mm (0.032 in)
• 0.914 mm (0.036 in)
• 1.016 mm (0.040 in)
• 1.118 mm (0.044 in)
• 1.219 mm (0.048 in)
• 1.321 mm (0.052 in)