LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Drive Pinion and Ring Gear Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the differential assembly. Refer to Differential Replacement .
  3. Remove the pinion yoke and the oil seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement .
    4. Fig 1: Installing J 22536 Or J 44421 On Pinion
    GM683960Courtesy of GENERAL MOTORS CORP.
  4. Install the J 22536  as shown. See Special Tools .

    Ensure that the J 22536  is firmly seated on the pinion. See Special Tools .

  5. Drive the pinion out using the J 22536  and a hammer. See Special Tools .

    Strike the J 22536  slowly. See Special Tools . Do not let the pinion fall out of the rear axle housing.

    6. Fig 2: View Of Collapsible Spacer & Pinion
    GM9731Courtesy of GENERAL MOTORS CORP.
  6. Remove the collapsible spacer from the pinion. Discard the spacer.
  7. Remove the pinion bearings and the cups. Refer to Drive Pinion Bearings Replacement .
    8. Fig 3: Identifying Ring Gear Bolts
    GM866503Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The ring gear bolts have left-hand threads.
  8. Remove the ring gear bolts. Discard the bolts.
    9. Fig 4: View Of From Differential Ring Gear Removal
    GM866502Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Ring Gear Removal Notice .
  9. Remove the ring gear from the differential. Drive the gear off with a brass drift if necessary.
scientia non olet · About LEMON Manuals