LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Drive Pinion Bearings Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the differential assembly. Refer to Differential Replacement .
  3. Remove the drive pinion from the axle. Refer to Drive Pinion and Ring Gear Replacement .
    4. Fig 1: Removing Inner Pinion Bearing Using Hydraulic Press
    GM680110Courtesy of GENERAL MOTORS CORP.
  4. Press the bearing off of the drive pinion using the J 22912-01  .
  5. Remove the shim.
    6. Fig 2: Removing Outer Pinion Bearing Cup
    GM889100Courtesy of GENERAL MOTORS CORP.
  6. Remove the outer pinion bearing cup from the axle housing using a hammer and a brass drift in the slots provided. Move the drift back and forth between one side of the cup and the other in order to work the cups out of the housing evenly.
    7. Fig 3: Removing Inner Pinion Bearing Cup
    GM889098Courtesy of GENERAL MOTORS CORP.
  7. Remove the inner pinion bearing cup from the axle housing using a hammer and a brass drift in the slots provided. Move the drift back and forth between one side of the cup and the other in order to work the cups out of the housing evenly.
scientia non olet · About LEMON Manuals