LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Differential Side Bearings Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential assembly. Refer to Differential Replacement .
    2. Fig 1: Identifying Special Tool J 22888-20A & Differential Side Bearing
    GM680400Courtesy of GENERAL MOTORS CORP.
  2. Remove the differential side bearings by performing the following steps:
    1. For the 8.6 inch and the 9.5 inch axles, install the differential assembly in a vise.
    2. Install the J 22888-20A  (2) and the J 8107-4  , 8.6 inch axle, or the J 36597  , 9.5 inch axle as shown.
    3. Remove the differential side bearings using the J 22888-20A  .
  3. Remove the differential assembly from the vise.
scientia non olet · About LEMON Manuals