LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Rear Drive Axle) >> Repair Instructions >> Differential Side Bearings Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Driving The Differential Side Bearing Into Position
    GM651740Courtesy of GENERAL MOTORS CORP.
  1. Install the differential side bearings by doing the following:
    1. In order to protect the differential case, install the J 8107-4  , 8.6 inch axle, or the J 36597  , 9.5 inch axle, in the case on the side opposite the bearing installation.
    2. Install the J 21784  , 8. See Special Tools .6 inch axle, or the J 29710  , 9.5 inch axle (2), and the J 8092  (1) onto the differential case bearing as shown.
    3. Drive the bearing onto the case using the J 21784  or the J 29710  and the J 8092  . See Special Tools .
  2. Install the differential assembly. Refer to Differential Replacement .
scientia non olet · About LEMON Manuals