LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Disc Brake System) >> Repair Instructions >> Rear Disc Brake Pads Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Components
    GM1699857Courtesy of GENERAL MOTORS CORP.
  1. Install the retaining springs (4) on the caliper mounting bracket (5).
  2. Install the brake pads (3).
    • Install the new brake pads.
    • Install the original brake pads in their original position.
  3. Remove the mechanics wire and rotate the brake caliper (2) into position on the mounting bracket (5).
  4. Install NEW caliper guide pin bolts.
    5. Fig 2: Using Open End Wrench To Loosen Brake Caliper Guide Pin Bolt
    GM1697372Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • DO NOT use any air tools to remove or tighten the guide pin bolts. Use hand tools ONLY.
    • Install an open end wrench to hold the caliper guide pins in line with the caliper while removing or installing the caliper. DO NOT allow the wrench to come in contact with the brake caliper. Allowing the wrench to come in contact with the brake caliper will cause a pulsation when the brakes are applied.
    NOTE: Refer to Fastener Notice .
  5. Use a open end wrench to hold the caliper guide pin while tightening the guide pin bolt.

    Tighten:  Tighten the bolt to 38 N.m (28 lb ft)

  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
  8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  9. Slowly release the brake pedal.
  10. Wait 15 seconds, then repeat steps 8-9 until a firm pedal is obtained, to properly seat the brake caliper pistons and brake pads.
  11. Fill the brake master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling .
  12. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing .
scientia non olet · About LEMON Manuals