LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper to the caliper mounting bracket.
    2. Fig 1: View Of Brake Caliper Mounting
    GM789166Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install brake caliper guide pin bolts.

    Tighten:  Tighten the bolts to 108 N.m (80 lb ft).

  3. Remove the cap or plug from the brake hose to caliper fitting.
    4. IMPORTANT: Install 2 NEW copper brake hose gaskets.
  4. Assemble the 2 copper brake hose gaskets to the brake to caliper bolt and the brake hose.
    5. Fig 2: View Of Brake Hose To Caliper Bolt
    GM367082Courtesy of GENERAL MOTORS CORP.
  5. Install the brake hose to caliper bolt.

    Tighten:  Tighten the bolts to 45 N.m (33 lb ft).

  6. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .
scientia non olet · About LEMON Manuals