LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Wiper Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Cycle the wipers 1 time to ensure they are in the parked position.
  1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
    2. Fig 1: Wiper Motor & Wiper Motor Transmission
    GM837507Courtesy of GENERAL MOTORS CORP.
  2. Remove the wiper transmission. Refer to Wiper Transmission Replacement .
  3. Mark the location of the wiper transmission arm prior to motor removal.
  4. Remove the nut retaining the wiper motor shaft to the wiper motor transmission.
  5. Remove the 3 fasteners (1) retaining the wiper motor to the wiper transmission.
  6. Remove the wiper motor from the wiper transmission.
scientia non olet · About LEMON Manuals