Wiper Motor Cover Replacement - Front

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Wiper Motor Cover Replacement - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the wiper arms. Refer to Wiper Arm Replacement . Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1	Windshield Wiper System Module Cover Assembly Tip: Disconnect the electrical connector from the cover. Use a flat bladed tool and release the five retainers that retain the module cover to the motor. For installation align the tang on the motor and push down to secure the retainers.

Callout

Component Name

Preliminary Procedures

Remove the wiper arms. Refer to Wiper Arm Replacement .
Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .

Windshield Wiper System Module Cover Assembly
Tip:

Disconnect the electrical connector from the cover.
Use a flat bladed tool and release the five retainers that retain the module cover to the motor.
For installation align the tang on the motor and push down to secure the retainers.