LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Wiper Arm Blade Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiper Blade Release Clip
    GM497480Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition switch to the ACCY position.
  2. Set the wiper switch to the PULSE position.
  3. Turn the ignition OFF when the wipers are in the innerwipe position and not moving.
  4. Push in the button of the wiper blade clip and remove the wiper blade from the inside radius of the wiper arm.
    5. Fig 2: Identifying Wiper Arm Hook & Blade
    GM497492Courtesy of GENERAL MOTORS CORP.
  5. Bring the wiper arm out through the opening in the wiper blade.
scientia non olet · About LEMON Manuals