LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Washer Hose Replacement - Washer Pump to Headliner Hose >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Tubing Routing
    GM1453810Courtesy of GENERAL MOTORS CORP.
  1. Position the washer pump to headliner hose (3) to the cowl area.
  2. Carefully seat the washer hose grommet to the cowl panel (5).
  3. Connect the washer hose (3) to the headliner hose (2) at the union (1).
  4. Install the upper I/P trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
  5. Install the right side interior windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
    6. Fig 2: Washer Solvent Level Sensor Electrical Connector
    GM1453811Courtesy of GENERAL MOTORS CORP.
  6. Seat the grommet (3) at the forward cowl panel.
  7. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals