LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Washer Hose Replacement - Liftgate (Body Side) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Liftgate Components
    GM1453836Courtesy of GENERAL MOTORS CORP.
  1. Position the hose end of the jumper harness (8) into the liftgate opening.
  2. Secure the hose onto the liftgate to the washer nozzle hose connection (12).
    3. Fig 2: Electrical Connections
    GM1453835Courtesy of GENERAL MOTORS CORP.
  3. Secure the jumper harness grommet (10) into the liftgate opening.
  4. Connect the electrical connector (9).
  5. Secure the washer hose to the headliner hose union.
  6. Carefully secure the jumper harness grommet (7) into the rear roof header (5).
  7. Ensure the grommet is fully seated into the roof header opening (4).
    8. Fig 3: Rear Upper Garnish Molding
    GM922459Courtesy of GENERAL MOTORS CORP.
  8. Install the rear interior garnish molding. Refer to Rear Upper Garnish Molding Replacement .
    9. Fig 4: Liftgate Trim Panel
    GM833482Courtesy of GENERAL MOTORS CORP.
  9. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
scientia non olet · About LEMON Manuals