LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Rear Window Wiper and Washer Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Wiper/Washer Switch
    GM832834Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the switch assembly.
  2. Push in the switch assembly until both tabs click in place.
  3. Install the trim bezel. Refer to Instrument Panel Accessory Trim Plate Replacement - Left Side .