LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Rear Window Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Wiper Motor
    GM1453829Courtesy of GENERAL MOTORS CORP.
  1. Position the rear wiper motor (4) into place in the liftgate (2).
  2. Install the fasteners retaining the wiper motor (4), but do not tighten.
    3. Fig 2: Rear Wiper Arm Nut & Weatherseal
    GM893157Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the weatherseal (4) and the rear wiper arm nut (3).

    Tighten:  Tighten the rear wiper arm nut to 6 N.m (4 lb ft).

  4. Tighten the rear wiper motor fasteners.

    Tighten:  Tighten the rear wiper motor fasteners to 9 N.m (7 lb ft).

  5. Connect rear wiper motor electrical connectors.
  6. Install the rear wiper motor control module.
  7. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement d.
  8. Install the beauty cover (1).
  9. Install the rear wiper arm. Refer to Rear Window Wiper Arm Replacement .
scientia non olet · About LEMON Manuals