LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Rear Window Wiper Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Wiper Arm
    GM892509Courtesy of GENERAL MOTORS CORP.
  1. Align the wiper arm to the vehicle by aligning the tip of the wiper to the locating mark (1) on the window.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nut retaining the wiper arm to the wiper motor.

    Tighten:  Tighten the nut to 17 N.m (12.5 lb ft).

  3. Swivel the wiper arm cover (2) closed.
  4. Connect the washer hose (4).
  5. Inspect the rear wiper for proper operation.
scientia non olet · About LEMON Manuals