LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wipers And Washers) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the non-functional air inlet caps. Refer to Air Inlet Grille Panel Replacement - Non Functional .
  2. Remove the wiper arms. Refer to Wiper Arm Replacement .
    3. Fig 1: Air Inlet Grille Panel
    GM837038Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the wiper hose connection (1).
  4. Using a flat-bladed tool, remove the push-in retainers (2).
  5. Remove the side fasteners.
  6. Using a flat-bladed tool, release the 4 retainers (3) securing the air inlet grille to the vehicle.
  7. Remove the air inlet grille from the vehicle.
scientia non olet · About LEMON Manuals