LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Tire Pressure Monitoring System) >> Repair Instructions >> Tire Pressure Sensor Replacement (Snap In Style) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a suitable support. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire/wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation .
  3. Dismount the tire from the rim. Refer to Tire Mounting and Dismounting .
    4. IMPORTANT: When servicing the tire pressure sensor always use a new Schrader® tire pressure monitor (TPM) and a new TORX screw during installation.
    Fig 1: View Of Tire Pressure Indicator Sensor, Valve Stem & Screws
    GM1748887Courtesy of GENERAL MOTORS CORP.
  4. Remove the TORX screw (1) from the tire pressure sensor (2) and pull it straight off the tire pressure valve stem (3).
    5. NOTE: Do not scratch or damage the clear coating on aluminum wheels with the tire changing equipment. Scratching the clear coating could cause the aluminum wheel to corrode and the clear coating to peel from the wheel.
  5. Remove the tire pressure valve stem by pulling it through the rim.
scientia non olet · About LEMON Manuals