LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Hydraulic Brake System) >> Repair Instructions >> Vacuum Brake Booster Check Valve and/or Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the vacuum brake booster check valve from the vacuum brake booster.
  2. Remove the vacuum brake booster hose clamp at the check valve.
  3. Remove the vacuum brake booster check valve from the hose.
  4. Remove the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9/LMG/LY5/L76/L92) or Intake Manifold Replacement (RPOs LY2/LY6) .
    5. Fig 1: View Of Vacuum Brake Booster Hose
    GM1697051Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the vacuum brake booster hose at the engine.
  6. Remove the vacuum brake booster hose from the vehicle.
scientia non olet · About LEMON Manuals