Rear Brake Hose Replacement (1500 Series)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Brake Hose & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to Brake Fluid Caution . CAUTION: Refer to Brake Fluid Irritant Caution . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Fitting, Brake Pipe Rear NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft) Tip: Remove any dirt or debris from the brake pipe fitting. The mounting bracket for the brake hose is serviced as part of the brake hose assembly and is not serviced separately. Use a backup wrench when removing or installing the brake pipe fitting. Cap the brake pipe fitting to prevent brake fluid loss or contamination.
2	Bolt, Brake Hose to Axle Rear Tighten: 9 N.m (80 lb in) Tip: Finger tighten mounting bolt before torquing to the specified value.
3	Bracket, Brake Hose to Axle Rear
4	Bolt, Brake Hose to Caliper Rear Tighten: 40 N.m (30 lb ft)
5	Gaskets, Brake Hose to Caliper (Qty: 2) Tip: Make sure the gaskets are not still attached to the brake hose or bolt, if not remove them. DO NOT re-use the gaskets. Install NEW gaskets.
6	Hose, Brake Rear Tip: When installing the brake hose, DO NOT twist or pinch the brake hose. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .