LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Fluid Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Compressing Master Cylinder Locking Tabs
    GM913273Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector from the fluid level sensor.
  2. Using needle nose pliers, compress the locking tabs at the opposite side of the master cylinder.
    3. Fig 2: View Of Master Cylinder Fluid Level Sensor
    GM913292Courtesy of GENERAL MOTORS CORP.
  3. Remove the fluid level sensor.
scientia non olet · About LEMON Manuals