LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pedal Stud, Stop Lamp Switch, Pushrod & Retaining Clip
    GM344194Courtesy of GENERAL MOTORS CORP.
  1. Remove the pushrod retaining clip (4).
  2. Remove the stop lamp switch (2) and the pushrod (3) from the brake pedal stud (1).
    3. Fig 2: View Of Brake Pedal Bolt & Nut
    GM375693Courtesy of GENERAL MOTORS CORP.
  3. Remove the nut from the brake pedal bolt.
  4. Remove the brake pedal bolt.
  5. Remove the brake pedal.
scientia non olet · About LEMON Manuals