LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Pedal Bolt & Nut
    GM375693Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal.
  2. Install the brake pedal bolt.
    3. NOTE: Refer to Fastener Notice .
  3. Install the nut to the brake pedal bolt.

    Tighten:  Hold the nut with a wrench and tighten the brake pedal bolt to 47 N.m (35 lb ft).

    4. Fig 2: View Of Pedal Stud, Stop Lamp Switch, Pushrod & Retaining Clip
    GM344194Courtesy of GENERAL MOTORS CORP.
  4. Install the pushrod (3) and the stop lamp switch (2) to the brake pedal pin (1).
  5. Install the pushrod retaining clip (4).
scientia non olet · About LEMON Manuals