LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Diagnosis & Troubleshooting) >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the Service Bay Test aborts or fails a DTC will NOT be set.
  1. Install a scan tool.
  2. Select the Service Bay Test with the scan tool.
    3. CAUTION: Refer to Road Test Caution .
  3. Follow the instructions on the scan tool.
    • If the test aborts, correct the condition for running the test and then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  4. Verify that the EVAP I/M system status is set to YES.
scientia non olet · About LEMON Manuals