LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B2508 or B2509 (Rear Seat) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the C1 harness connector at the heated seat module.
  2. Test for infinite resistance between the left seat heating element supply voltage circuit terminal 3 and ground.
    • If less than infinite resistance, test the supply voltage circuit and the seat cushion heating element control circuit for a short to ground.
  3. Ignition ON, verify that a test lamp does not illuminate between the supply voltage circuit terminal 3 and ground.
    • If the test lamp illuminates, test the supply voltage circuit and the seat cushion heating element control circuit for a short to voltage.
  4. Test for infinite resistance between the right seat heating element supply voltage circuit terminal 6 and ground.
    • If less than infinite resistance, test the supply voltage circuit and the seat cushion heating element control circuit for a short to ground.
  5. Ignition ON, verify that a test lamp does not illuminate between the supply voltage circuit terminal 6 and ground.
    • If the test lamp illuminates, test the supply voltage circuit and the seat cushion heating element control circuit for a short to voltage.
  6. If all circuits test normal, replace the heated seat module.
scientia non olet · About LEMON Manuals