LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B1925 or B2170 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the MSM or rear heated seat module harness connector C5 for driver or front passenger seat or C4 for a rear passenger seat.
  2. Test for a minimum of 850 ohms of resistance from the signal circuit to ground.
    • If less than 850 ohms, test the signal circuit for a short to ground. If the circuit tests normal, replace the seat cushion heater element.
  3. If all circuits test normal, replace the MSM or rear heated seat module.
scientia non olet · About LEMON Manuals