LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Luggage Rack And Roof Trim) >> Repair Instructions >> Luggage Carrier Side Rail End Cap Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clearance Lamp Bulb (SUV)
    GM803117Courtesy of GENERAL MOTORS CORP.
  1. Remove the clear clearance lamp. Refer to Clearance Lamp Replacement (SUT Front) or Clearance Lamp Replacement (SUT Rear) or Clearance Lamp Replacement (SUV) .
  2. If equipped with a luggage carrier cross car rail, loosen the lock knobs and slide the rails forward.
  3. Remove the rear luggage rail screw.
    4. Fig 2: Locating Luggage Rail Screw
    GM1427917Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear end cap screw.
  5. Disengage the rear end cap from the rear luggage rail.
    6. Fig 3: Side Rail End Cap
    GM1428256Courtesy of GENERAL MOTORS CORP.
  6. Remove the side rail end cap from the roof panel.
scientia non olet · About LEMON Manuals