Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Side Rail End Cap

Courtesy of GENERAL MOTORS CORP.

Position the side rail end cap to the roof panel.
Lock the forward edge of the end cap into the luggage carrier rail.

NOTE: Refer to Fastener Notice .

Install the luggage rail screw to the end cap side rail.
Tighten: Tighten the screw to 10 N.m (89 lb in).

Fig 2: Locating Luggage Rail Screw

Courtesy of GENERAL MOTORS CORP.

Install the rear end cap screw.
Tighten: Tighten the end cap screw to 10 N.m (89 lb in).
If equipped with a luggage carrier cross rail, reposition and secure the lock knobs.

Fig 3: Clearance Lamp Bulb (SUV)

Courtesy of GENERAL MOTORS CORP.

Install the clear clearance lamp. Refer to Clearance Lamp Replacement (SUT Front) or Clearance Lamp Replacement (SUT Rear) or Clearance Lamp Replacement (SUV) .