Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
It is necessary to use the following alignment marks when aligning the front cross bar. Marks are located on the top surface of the passenger side roof rail, and should be aligned with the arrow (1) on the crossbar. All roof rack kits include a stop clip, which should be placed on the roof rail in the appropriate stop location. Failure to align to these marks could result in component interference and excessive wind noise.
On vehicles not equipped with sunroofs, align the front cross bar with the On-Star stop (1), located approximately 7.5 inches behind the front outer marking light.
On vehicles equipped with sunroofs, align the arrow on the cross bar with the sunroof stop (1), located approximately 20 inches rearward on the OnStar stop.
- Install the luggage carrier rail to the roof panel.
- Install the bolts to the side rails.
Tighten: Tighten the bolts to 9 N.m (7 lb ft).
- Install the front clearance lamps to the side rails by inserting the locator tab and lowering into place, then insert the screw.
Tighten: Tighten the screw to 3 N.m (26 lb in).
- Install the rear clearance lamps to the side rails.
Tighten: Tighten the screws to 3 N.m (26 lb in).
- Install the cross rails by sliding the cross rails from the rear of the vehicle. Tighten the lock knobs at the detent locator marks (1).
- Install the side rail covers by clipping the covers to the luggage carrier side rails.
- Close both side doors.
NOTE:
Refer to Fastener Notice
.