LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Luggage Rack And Roof Trim) >> Repair Instructions >> Hard Cargo Carrier Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cross Bar End Caps
    GM857570Courtesy of GENERAL MOTORS CORP.
  1. Remove the end caps to the cross bars on the roof rack.
  2. Fig 2: Straps & Brackets
    GM857583Courtesy of GENERAL MOTORS CORP.
  3. Remove the straps through the eyes of the brackets.
  4. Loosen the attaching hardware and remove cargo box from top of vehicle.
  5. Slide the assembly from T-slot of roof rack cross bar.
  6. Remove using the knobs from end of T-bolts.
  7. Fig 3: T-Bolts & Hard Cargo Carrier
    GM857576Courtesy of GENERAL MOTORS CORP.
  8. Remove the T-bolts from underneath the heard cargo carrier.
  9. Fig 4: End Caps On Cross Bars
    GM857592Courtesy of GENERAL MOTORS CORP.
  10. Install the end caps on cross bars of the roof rack.