LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiring Systems And Power Management - Troubleshooting & Diagnosis) >> Testing for Short to Ground >> With a DMM

With a DMM

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power feed (i.e. fuse, control module) from the suspect circuit.
  2. Disconnect the load.
  3. Set the rotary dial of the DMM to the ohm position.
  4. Connect one lead of the DMM to one end of the circuit to be tested.
  5. Connect the other lead of the DMM to a good ground.
  6. If the DMM does NOT display infinite resistance (OL), there is a short to ground in the circuit.
scientia non olet · About LEMON Manuals