LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiring Systems And Power Management - Troubleshooting & Diagnosis) >> Molex Connectors >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate the connector position assurance (CPA) on the top of the wire dress cover. Slide the CPA forward.
    Fig 1: Identifying Lever Lock Release Tab
    GM1709320Courtesy of GENERAL MOTORS CORP.
  2. Slide the lever lock forward while pressing down on the lever lock release tab.
    Fig 2: View Of Lever In Full Forward Position
    GM1709258Courtesy of GENERAL MOTORS CORP.
    Fig 3: View Of CPA Connector
    GM1709322Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the connector from the component.
    4. Fig 4: View Of Dress Cover
    GM1572878Courtesy of GENERAL MOTORS CORP.
  4. Remove the dress cover by using a flat bladed tool to release the dress cover locking tabs and lift up on the dress cover.
  5. Cut the tie wrap that holds the wires to the connector body.
    6. Fig 5: Prying One Side Of Nose Piece
    GM1572905Courtesy of GENERAL MOTORS CORP.
  6. Use a small flat-blade tool to pry one side of the nose piece up to the pre-stage position. When the nose piece is in the pre-staged position, the nose piece will be raised above the connector body the length of the step in the nose piece.
    7. Fig 6: Prying Other Side Of Nose Piece
    GM1572908Courtesy of GENERAL MOTORS CORP.
  7. Use a small flat-blade tool to pry the other side of the piece to the pre-stage position. If the nose piece is higher than the first step in the nose piece, gently push down on the nose piece until it meets with resistance from the connector body, you should feel the nose piece click into position.
    8. Fig 7: Inserting J 38125-213 Into Small Terminal Release Hole
    GM1572911Courtesy of GENERAL MOTORS CORP.
  8. Insert the J 38125-213 into the small terminal release hole on the nose piece and gently pull on the back of the wire.
  9. See the release tool cross reference in the Reference Guide of the J-38125  Terminal Repair Kit to ensure that the correct release tool is used. See Special Tools .
scientia non olet · About LEMON Manuals