LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiring Systems And Power Management - Troubleshooting & Diagnosis) >> Ignition Key Cannot Be Removed from the Ignition Lock Cylinder

Ignition Key Cannot Be Removed from the Ignition Lock Cylinder

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Ignition Key Cannot Be Removed from the Ignition Lock Cylinder

Step Action Yes No
1 Did you review the Steering Wheel and Column Description and Operation? Go to Step 2  Go to Steering Wheel and Column Description and Operation
2 Verify that the key cannot be removed from the lock cylinder.
Does the lock system operate normally?
Go to Step 3  System OK
3 Is the vehicle equipped with a manual transmission? Go to Step 7  Go to Step 4 
4 Turn the ignition key to the OFF position.
Can the key be turned to the OFF position and be removed?
Go to Step 7  Go to Step 5 
5 Verify the adjustment of the automatic transmission cable. Refer to the appropriate procedure:
Can the key be turned to the OFF position?
System OK Go to Step 6 
6 Inspect the linear shift assembly and cable for damage.
Is the linear shift assembly or cable damaged?
Go to Step 9  Go to Step 7 
7 Inspect for a faulty lock cylinder.
Is the lock cylinder damaged?
Go to Step 10  Go to Step 8 
8 Inspect the ignition lock cylinder case.
Is the case worn, damaged or loose?
Go to Step 11  Go to Step 12 
9 Replace the linear shift assembly. Refer to Linear Shift Assembly Replacement .
Did you complete the repair?
Go to Step 12  -
10 Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
Did you complete the repair?
Go to Step 12  -
11 Replace the ignition lock cylinder case housing. Refer to Ignition Lock Cylinder Case Replacement .
Did you complete the repair?
Go to Step 12  -
12 Operate the system to verify the repair.
Did you correct the condition?
System OK Go to Step 2