LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiring Systems And Power Management - Troubleshooting & Diagnosis) >> Bosch Connectors (0.64) >> Terminal Replacement Procedure

Terminal Replacement Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Coding Lugs With Connector Coding Grooves
    GM1442741Courtesy of GENERAL MOTORS CORP.
  1. Prior to installation the terminal must be aligned so the (1) coding lugs align with the (2) coding grooves on the connector.
  2. Once the terminal is aligned, slide the terminal into the cavity until the retainer has engaged in the cavity of the connector.
  3. Slide the TPA in the connector body and seat it using a small flat bladed tool. The TPA is seated when it is flush with the contact housing.
  4. Secure the wires to the connector body using a tie wrap and replace the dress cover and grommet.
scientia non olet · About LEMON Manuals