LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Vehicle Diagnostic Information) >> Diagnostic Information and Procedures >> Diagnostic Procedure Instructions >> Diagnostic Fault Information

Diagnostic Fault Information

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The diagnostic Fault Information table identifies each circuit that makes up an electrical subsystem and the associated circuit faults. DTCs and symptoms are listed in the table for all circuit fault modes. This information can be used to diagnose an electrical fault, or as a quick visual aid showing how the different symptoms and DTCs apply for the subsystem being diagnosed.

Even though all the DTCs and symptoms are shown in this table it does not mean they will all be diagnosed in the same procedure.

An example table from an ECT procedure:

Diagnostic Procedure Instructions

Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
ECT Sensor Signal P0117 P0118 P0118 P0125
P0128
ECT Low Reference   P0118 P0118 P0125
P0128