LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Adjustable Pedal System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 master cylinder nuts.
    2. IMPORTANT: DO NOT disconnect the hydraulic brake pipes from the master cylinder.
  2. Position the master cylinder aside and support with heavy mechanics wire or equivalent.
  3. Remove the steering column from the vehicle. Refer to Steering Column Replacement .
    4. Fig 1: View Of Bolt Securing Selector Cable To Brace
    GM394467Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission range selector cable support bolt from the instrument panel (I/P) reinforcement brace.
  5. Disconnect the electrical connectors from the following components:
    • The adjustable pedals motor assembly
    • The memory sensor connector, if equipped
    • The pedal position sensor
    • The accelerator wiring harness connector
    6. Fig 2: View Of Accelerator Pedal Position Sensor Assembly
    GM1704147Courtesy of GENERAL MOTORS CORP.
  6. Remove the accelerator pedal position sensor assembly. Refer to Accelerator Pedal Position Sensor Replacement .
  7. Remove the left side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side .
    8. Fig 3: View Of Brake Pedal Components
    GM1704202Courtesy of GENERAL MOTORS CORP.
  8. Remove the pushrod retaining clip (1) from the brake pedal pin (4).
  9. Remove the brake pedal pushrod (5) and the stop lamp switch (2) from the brake pedal (3).
    10. Fig 4: View Of EAP Bracket Nuts, Booster Studs & Bracket Bolt
    GM1704242Courtesy of GENERAL MOTORS CORP.
  10. Remove the electronic adjustable pedal (EAP) bracket nuts (2) from the brake booster studs (3).
  11. Remove the top EAP bracket bolt (1).
  12. Move the brake booster forward until the studs are past the EAP bracket holes.
  13. Remove the EAP assembly from the vehicle.
scientia non olet · About LEMON Manuals