LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Adjustable Pedal System) >> Diagnostic Information and Procedures >> DTC B3604 or B3605 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the adjustable pedal switch connector.
  2. Ignition ON, verify that both adjustable pedal switch parameters to the memory seat module are Inactive.
    • If 1 of the switch parameters is always Active test the affected switch signal circuit for a short to voltage. If the signal circuit tests normal replace the memory seat module.
  3. If the circuit tests normal replace the adjustable pedal switch.
scientia non olet · About LEMON Manuals