LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Tires And Wheels) >> Repair Instructions >> Tire and Wheel Removal and Installation >> Tools Required >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the wheel center cap.
    3. Fig 1: View Of Tire/Wheel Assembly, Hub Assembly & Wheel Nuts
    GM656803Courtesy of GENERAL MOTORS CORP.
  3. Remove the wheel nuts from the tire and wheel.
  4. Mark the location of the tire and wheel to the hub assembly.
  5. Remove the tire and wheel from the vehicle.
  6. Clean the wheel nuts, studs and the wheel and rotor mounting surfaces.
scientia non olet · About LEMON Manuals