LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Tires And Wheels) >> Repair Instructions >> Tire Hoist and Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spare Tire Hoist Shaft Guide
    GM385768Courtesy of GENERAL MOTORS CORP.
  1. Install the spare tire hoist shaft guide to the bumper.
    2. Fig 2: View Of Tire Hoist, Bracket & Bolt
    GM355994Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the hoist to the crossmember.
  3. Install the bolt.

    Tighten:  Tighten the bolt to 40 N.m (30 lb ft).

  4. Install the collar to the hoist
  5. Install the shaft to the hoist.
    6. Fig 3: View Of Spare Tire
    GM385791Courtesy of GENERAL MOTORS CORP.
  6. Install the spare tire to the hoist.
    7. NOTE: Use only hand tools to lower and raise the spare tire hoist assembly. Do not use air tools. The use of air tools at high speeds will damage the spare tire hoist assembly.
  7. Rotate the hoist shaft clockwise until the spare tire is in position and the hoist clicks 2 times or it skips twice. You cannot overtighten the cable.
  8. Remove the safety stands.
  9. Lower the vehicle.
    10. Fig 4: Locating Spare Tire
    GM385766Courtesy of GENERAL MOTORS CORP.
  10. Install the spare tire stowage lock cylinder.
scientia non olet · About LEMON Manuals